01. Check whether the number of joints on the product section is consistent with the number you have connected. If the hot melt adhesive coating machine does not match, immediately rewind and check to prevent the inner joints from being mixed into the product.

02. According to the characteristics of semi-finished products, adjust the EPC device to ensure that the EPC photoelectric is always on the tracking line, and the film is turned on at a low speed by pulling one end of the film by hand.

03. Stop pressing the stop button. When unloading, the hand is not allowed to touch the reel, so as to avoid fingers being pinched.

04. Start the machine at a slow speed, observe whether the slitting film meets the quality requirements, and then slowly accelerate to start slitting. When the machine is running, it is strictly forbidden to put your hand into the machine to avoid pressing the back of your hand.

05. Open (close) the raw material bracket to a suitable width, and place the semi-finished film roll to be cut on the bracket. When feeding, the hand must leave the section of the film roll, and two people are not allowed to operate at the same time to prevent hand caught by the cylinder.

06. Return the photoelectric to the center position to ensure that the slider of the unwinding table is kept in the proper position in the middle of the guide roller.

07. Put the paper tube that meets the specifications on the rewinding shaft, put the cut products that meet the requirements on the paper tube of the upper and lower rewinding shafts that are pulled according to the normal method, start the machine at low speed, and find out that the paper tube is suitable on the rewinding shaft mark the location for the next installation. When installing the paper tube, you must hold the surface of the paper tube tightly to prevent it from falling off and being bumped by the shaft.