When we are using the machine, if its use effect does not meet our requirements or standards, we have to find out the reason, where is it, and the same is true for the automatic labeling machine, then the configuration table plane labeling machine What are the top six reasons for unstable labeling?

    1. The belt pressing device may not be pressed tightly, resulting in the loosening of the label and the inaccurate detection of the electric eye. Squeeze the label to solve.
    2. It is possible that the traction mechanism slips or is not pressed tightly, so that the bottom paper cannot be taken away smoothly. It can be solved by pressing the traction mechanism. If it is too tight, the label will be pulled out. It is better to be able to pull the bottom paper normally. (Usually if the backing paper is wrinkled when pulled out, it should be pressed too tightly)
 3. The shape of the object to be pasted is different or the positioning is different. Control product quality.
 4. The object to be attached should be placed parallel to the direction of the label (pay attention to whether the product moves during the labeling process, and the left support rod can be appropriately raised a little higher than the right)
 5. The object to be attached should rotate smoothly on the labeling station (be careful not to touch the peeling plate). When the object is too light, put down the sticker and press the object to be attached.
 6. In the double-label state, after the Configuration table plane labeling machine outputs a single label, the workpiece keeps rotating because there is no delay set for the second label, and the machine is in a state of waiting for the labeling signal of the second label. When a single label is issued, the workpiece stops. It is because there is signal interference in the target measuring electric eye (reset the electric eye) or the delay control is abnormal (after clicking jog 2 twice, click jog 1 twice again.